Hobbywing Ezrun 3652 G3 Sensored Brushless Motor, 3300kv, for Short Course T

About this part

Ezrun 3652 G3 sensored brushless motor, 3300KV, for short course use. The G3 has an improved waterproof sensored cable interface and an upgraded sensored mode for motor temperature protection. It matches the EzRun MAX10 G2 ESC. The high-precision Hall sensor gives a consistent, accurate rotor position output, for linear response and good throttle control. The front bearing is high-precision and waterproof. The rear end uses a smaller precision iron cover that raises capacity and bearing speed while keeping resistance low, so the motor runs smoother and more reliably. Compared with the G2, the motor runs much cooler under the same load. Efficiency is 3% higher, and maximum output power is up 5%. The casing, bearings, ultra-thin silicon steel sheets, high-temperature copper wire, explosion-proof rotor, and high-tolerance aluminum shaft were selected and approved by in-house engineers.